(1) Pressure guide tube thickness should be appropriate, the general inner diameter is 6 10mm, the length should be as short as possible, the maximum length should not be more than 50M, in order to reduce the delay of pressure indication. Se superior a 50m, deve ser selecionado o manômetro que pode transmitir a longa distância.
(2) When the pressure guide pipe is installed horizontally, it should be guaranteed to have a tilt of 1:10 1:20 to facilitate the discharge of the liquid (or gas) accumulated in it.
(3)Quando o meio medido é fácil de condensar ou congelar, é necessário adicionar uma tubulação de rastreamento de preservação de calor.
(4)There should be a cut-off valve between the pressure outlet and the pressure gauge to prepare for the use of maintenance pressure timing. A válvula de corte-deve ser instalada próxima à saída de pressão.






